News

New VHW lock case milling cutter for high requirements

This cutter Ø16 x 25/115/175 x Ø16, Z = 3, negative, supplements the LEUCO lock case cutter range and can be ordered with Ident-No. 186763 from stock.
This cutter Ø16 x 25/115/175 x Ø16, Z = 3, negative, supplements the LEUCO lock case cutter range and can be ordered with Ident-No. 186763 from stock.

Negative has a positive effect:


Door production in the high-performance sector is often accompanied by short cycle times, high feed rates and the desire for long edgelife. This places the highest demands on drive spindles, clamping devices and tools on the CNC machine.

This also applies for the solid carbide lock case cutters used. Wear-resistant carbide, good chip removal and infeed movements and reverse paths, as gentle as possible guarantee long edgelife and contribute to minimizing the risk of breakage.

LEUCO now offers a solid carbide lock case roughing cutter version, which has proven its worth in the high-performance door production for quite some time.

The most striking features of this tool are on the one hand the negative spiral winding, on the other hand the special fine toothing of the roughing area.

In use, the lock VHW case milling cutter impresses with its extremely quiet and low-vibration running. The chips also flow well with the negative spiral arrangement.

News Overview

To the archive